98 lines
2.4 KiB
YAML
98 lines
2.4 KiB
YAML
|
# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
|
||
|
|
%YAML 1.2
|
||
|
|
---
|
||
|
|
$id: http://devicetree.org/schemas/media/i2c/ovti,og0ve1b.yaml#
|
||
|
|
$schema: http://devicetree.org/meta-schemas/core.yaml#
|
||
|
|
|
||
|
|
title: OmniVision OG0VE1B Image Sensor
|
||
|
|
|
||
|
|
description:
|
||
|
|
OmniVision OG0VE1B image sensor is a low power consuming monochrome
|
||
|
|
image sensor. The sensor is controlled over a serial camera control
|
||
|
|
bus protocol (SCCB), the widest supported image size is 640x480 at
|
||
|
|
120 frames per second rate, data output format is 8/10-bit RAW
|
||
|
|
transferred over one-lane MIPI D-PHY at up to 800 Mbps.
|
||
|
|
|
||
|
|
maintainers:
|
||
|
|
- Vladimir Zapolskiy <vladimir.zapolskiy@linaro.org>
|
||
|
|
|
||
|
|
allOf:
|
||
|
|
- $ref: /schemas/media/video-interface-devices.yaml#
|
||
|
|
|
||
|
|
properties:
|
||
|
|
compatible:
|
||
|
|
const: ovti,og0ve1b
|
||
|
|
|
||
|
|
reg:
|
||
|
|
maxItems: 1
|
||
|
|
|
||
|
|
clocks:
|
||
|
|
description: XVCLK supply clock, 6MHz to 27MHz frequency.
|
||
|
|
maxItems: 1
|
||
|
|
|
||
|
|
reset-gpios:
|
||
|
|
description: Active low GPIO connected to XSHUTDOWN pad of the sensor.
|
||
|
|
maxItems: 1
|
||
|
|
|
||
|
|
strobe-gpios:
|
||
|
|
description: Input GPIO connected to strobe pad of the sensor.
|
||
|
|
maxItems: 1
|
||
|
|
|
||
|
|
avdd-supply:
|
||
|
|
description: Analog voltage supply, 2.6 to 3.0 volts.
|
||
|
|
|
||
|
|
dovdd-supply:
|
||
|
|
description: Digital I/O voltage supply, 1.7 to 3.0 volts.
|
||
|
|
|
||
|
|
dvdd-supply:
|
||
|
|
description: Digital core voltage supply.
|
||
|
|
|
||
|
|
port:
|
||
|
|
$ref: /schemas/graph.yaml#/$defs/port-base
|
||
|
|
additionalProperties: false
|
||
|
|
|
||
|
|
properties:
|
||
|
|
endpoint:
|
||
|
|
$ref: /schemas/media/video-interfaces.yaml#
|
||
|
|
unevaluatedProperties: false
|
||
|
|
|
||
|
|
required:
|
||
|
|
- link-frequencies
|
||
|
|
|
||
|
|
required:
|
||
|
|
- compatible
|
||
|
|
- reg
|
||
|
|
- port
|
||
|
|
|
||
|
|
unevaluatedProperties: false
|
||
|
|
|
||
|
|
examples:
|
||
|
|
- |
|
||
|
|
#include <dt-bindings/gpio/gpio.h>
|
||
|
|
|
||
|
|
i2c {
|
||
|
|
#address-cells = <1>;
|
||
|
|
#size-cells = <0>;
|
||
|
|
|
||
|
|
camera@3e {
|
||
|
|
compatible = "ovti,og0ve1b";
|
||
|
|
reg = <0x3e>;
|
||
|
|
clocks = <&camera_clk 0>;
|
||
|
|
assigned-clocks = <&camera_clk 0>;
|
||
|
|
assigned-clock-rates = <24000000>;
|
||
|
|
reset-gpios = <&gpio1 10 GPIO_ACTIVE_LOW>;
|
||
|
|
avdd-supply = <&vreg_2p8>;
|
||
|
|
dovdd-supply = <&vreg_1p8>;
|
||
|
|
dvdd-supply = <&vreg_1p2>;
|
||
|
|
|
||
|
|
port {
|
||
|
|
endpoint {
|
||
|
|
link-frequencies = /bits/ 64 <500000000>;
|
||
|
|
remote-endpoint = <&mipi_csi2_ep>;
|
||
|
|
};
|
||
|
|
};
|
||
|
|
};
|
||
|
|
};
|
||
|
|
|
||
|
|
...
|